The use of wood peeling machine is stuck, what happened? Encountered such a situation must first shut down power, then check what reason is stuck, the general need to check the blade Is it right? Not tighten, or take too long blade sharpening, belt slippage or damage, as the case adjustment and replacement, or processed wood hardness is too high, too difficult to machine, the machine power caused by the small card, the installation angle of the cutter head, or sharp enough, depending on the circumstances, one investigation will find the cause of the problem, do not blindly remove, to avoid the occurrence of two damage, an antidote against the disease in order to solve the fundamental problem